ZyXEL Communications Omni 56K II - Manual (Page 78)

Omni 56K II and Omni 56K Plus II User’s Guide
5-32 Command Sets
COMMAND BIT DEC HEX FUNCTION AND DESCRIPTION REF.
7 128 80 Enable extended numerical result codes from 50 to 65
when an error corrected connection is made. Use with
ATV0 (see result code table). V0
S23.6
bit dec hex Bit-mapped register. +000
0 1 1 Repeatedly dials the default number if not connected. *Dn, S29
3 0 0 CD tracks the carrier (default). &C0
3 8 8 The DCD ON/OFF sequence follows UNIX standard,
DCD ON before connect message is sent, DCD off
after the last DCE response is sent. &C1,
S21.4
4 16 10 Auto-mode fax receiving is disabled, hangs up if a fax
call is received (default). &N0
S38=
5 32 20 Disable MNP5 negotiation. &Kn
bit dec hex Bit-mapped register. +032 S39
2 4 4 Reverse the answers. Answer in originating mode. ATA
bit dec hex Bit-mapped register. +000
1 2 2 No result code is displayed in answer mode. Q2
2 4 Enables caller ID detection.
3 8 Enables type 1 ring detection.
4 16 Enables type 2 ring detection.
5 32 Enables type 3 ring detection.
S40=
6 64 Enables type 4 ring detection.
bit dec hex Bit-mapped register. +000
0 1 1 Special MNP compatibility. (see also s27.0, S38.5) &Kn
3 8 8 Enable CCITT signals 140 and 141 on EIA-232D
interface.
4 16 10 In X2-X7 setting, modem waits for S6 seconds before
dialing and ignores dial tone detection.
5 32 20 DSR follows DCD and pulses for 0.5 sec after DCD
on-off transition. &Sn
S41=
6 64 40 Force S0>=2; does not answer on the first ring. S0