ZyXEL Communications NBG334W - Manual (Page 87)

Chapter 5 Wireless LAN
NBG334W User’s Guide
87
Figure 41 Network > Wireless LAN > Advanced
The following table describes the labels in this screen.
Table 33 Network > Wireless LAN > Advanced
LABEL DESCRIPTION
Roaming Configuration
Enable
Roaming
Select this option if your network environment has multiple APs and you want your
wireless device to be able to access the network as you move between wireless
networks.
Wireless Advanced Setup
RTS/CTS
Threshold
Data with its frame size larger than this value will perform the RTS (Request To
Send)/CTS (Clear To Send) handshake.
If the RTS/CTS value is greater than the Fragmentation Threshold value, then the
RTS/CTS handshake will never occur as data frames will be fragmented before they
reach RTS/CTS size.
Enter a value between 0 and 2432.
Fragmentation
Threshold
It is the maximum data fragment size that can be sent. Enter a value between 256
and 2432.
Enable Intra-
BSS Traffic
A Basic Service Set (BSS) exists when all communications between wireless clients
or between a wireless client and a wired network client go through one access point
(AP).
Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-BSS is
enabled, wireless client A and B can access the wired network and communicate
with each other. When Intra-BSS is disabled, wireless client A and B can still access
the wired network but cannot communicate with each other.
Output Power Set the output power of the NBG334W in this field. If there is a high density of APs
within an area, decrease the output power of the NBG334W to reduce interference
with other APs.
802.11 Mode Select 802.11b to allow only IEEE 802.11b compliant WLAN devices to associate
with the NBG334W.
Select 802.11g to allow only IEEE 802.11g compliant WLAN devices to associate
with the NBG334W.
Select 802.11b/g to allow either IEEE802.11b or IEEE802.11g compliant WLAN
devices to associate with the NBG334W. The transmission rate of your NBG334W
might be reduced.