ZyXEL Communications NBG334W - Manual (Page 118)

Chapter 9 Guest WLAN
NBG334W User’s Guide
118
9.1 General Guest WLAN Screen
Click Network > Guest WLAN to open the General screen.
Figure 64 Network > Guest WLAN > General
The following table describes the general wireless LAN labels in this screen.
9.2 Guest WLAN MAC Filter
The MAC filter screen allows you to configure the NBG334W to give exclusive access
(Allow) or exclude devices from accessing the NBG334W’s guest wireless network (Deny).
Every Ethernet device has a unique MAC (Media Access Control) address. The MAC address
is assigned at the factory and consists of six pairs of hexadecimal characters, for example,
00:A0:C5:00:00:02. You need to know the MAC address of the devices to configure this
screen.
For comparing the NBG334W’s Guest WLAN and wireless LAN, see
Appendix A on page
229 .
Table 44 Network > Guest WLAN > General
LABEL DESCRIPTION
Enable Guest
WLAN
Select the check box to activate guest wireless LAN.
Name(SSID) The SSID (Service Set IDentity) identifies a wireless station. Wireless stations
associating to the access point (AP) must have the same SSID. Enter a descriptive
name (up to 32 printable 7-bit ASCII characters) for the wireless LAN. Use the
default SSID (Guest) or enter a unique name in order to distinguish it from other
wireless networks in the same area.
Hide SSID Select this check box to hide the SSID in the outgoing beacon frame so a station
cannot obtain the SSID through scanning using a site survey tool.
Security Mode Select this to specify the security level for this wireless network. Select Static WEP,
WPA-PSK, WPA, WPA-PSK2, or WPA2, the corresponding settings display below.
Or select No Security to not apply security setting for this wireless network. See
Section 5.5.1 on page 81 , Section 5.5.2 on page 81 , Section 5.5.3 on page 83 ,
Section 5.5.4 on page 84 for more information.
Apply Click Apply to save your changes back to the NBG334W.
Reset Click Reset to reload the previous configuration for this screen.