ZyXEL Communications NBG334W - Manual (Page 156)

Chapter 15 Static Route Screens
NBG334W User’s Guide
156
Figure 85 Management > Static Route > IP Static Route
The following table describes the labels in this screen.
15.2.1 Static Route Setup Screen
To edit a static route, click the edit icon under Modify. The following screen displays. Fill in
the required information for each static route.
Table 59 Management > Static Route > IP Static Route
LABEL DESCRIPTION
# This is the index number of an individual static route. The first entry is for the
default route and not editable.
Name This is the name that describes or identifies this route.
Active This icon is turned on when this static route is active.
Click the Edit icon under Modify and select the Active checkbox in the Static
Route Setup screen to enable the static route. Clear the checkbox to disable this
static route without having to delete the entry.
Destination This parameter specifies the IP network address of the final destination. Routing
is always based on network number.
Gateway This is the IP address of the gateway. The gateway is an immediate neighbor of
your NBG334W that will forward the packet to the destination. On the LAN, the
gateway must be a router on the same segment as your NBG334W; over the
WAN, the gateway must be the IP address of one of the remote nodes.
Modify Click the Edit icon to open the static route setup screen. Modify a static route or
create a new static route in the Static Route Setup screen.
Click the Remove icon to delete a static route.