ZyXEL Communications NBG334W - Manual (Page 81)

Chapter 5 Wireless LAN
NBG334W User’s Guide
81
5.5.1 No Security
Select No Security to allow wireless stations to communicate with the access points without
any data encryption.
"
If you do not enable any wireless security on your NBG334W, your network is
accessible to any wireless networking device that is within range.
Figure 36 Network > Wireless LAN > General: No Security
The following table describes the labels in this screen.
5.5.2 WEP Encryption
WEP encryption scrambles the data transmitted between the wireless stations and the access
points to keep network communications private. It encrypts unicast and multicast
communications in a network. Both the wireless stations and the access points must use the
same WEP key.
Your NBG334W allows you to configure up to four 64-bit or 128-bit WEP keys but only one
key can be enabled at any one time.
In order to configure and enable WEP encryption; click Network > Wireless LAN to display
the General screen. Select Static WEP from the Security Mode list.
Table 28 Wireless No Security
LABEL DESCRIPTION
Security Mode Choose No Security from the drop-down list box.
Apply Click Apply to save your changes back to the NBG334W.
Reset Click Reset to reload the previous configuration for this screen.