ZyXEL Communications NBG334W - Manual (Page 170)

Chapter 17 Remote Management
NBG334W User’s Guide
170
1 You have disabled that service in one of the remote management screens.
2 The IP address in the Secured Client IP Address field does not match the client IP
address. If it does not match, the NBG334W will disconnect the session immediately.
3 There is already another remote management session with an equal or higher priority
running. You may only have one remote management session running at one time.
4 There is a firewall rule that blocks it.
17.1.2 Remote Management and NAT
When NAT is enabled:
• Use the NBG334W’s WAN IP address when configuring from the WAN.
• Use the NBG334W’s LAN IP address when configuring from the LAN.
17.1.3 System Timeout
There is a default system management idle timeout of five minutes (three hundred seconds).
The NBG334W automatically logs you out if the management session remains idle for longer
than this timeout period. The management session does not time out when a statistics screen is
polling. You can change the timeout period in the System screen
17.2 WWW Screen
To change your NBG334W’s World Wide Web settings, click Management > Remote
MGMT to display the WWW screen.
Figure 92 Management > Remote MGMT > WWW
The following table describes the labels in this screen
Table 69 Management > Remote MGMT > WWW
LABEL DESCRIPTION
Server Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Server Access Select the interface(s) through which a computer may access the NBG334W using
this service.