Xerox Document WorkCentre 450C - Manual (Page 72)

72
10. Press RIGHT ARROW to display [charge code] and
ENTER.
11. Enter the charge code. A dollar sign ($) displays for each
number in the charge code. The dollar signs display after
the fax number.
12. When you are done entering the charge code, press
PAUSE . Any additional numbers you might enter will
display on the LCD.
13. Do one of the following:
• Press START to begin the fax transmission.
• Press ENTER , add another fax number, and then press
START .
Note After the fax is sent, you may want to change the
PAUSE key setting to pause only. Repeat steps 1
through 5 and choose pause only in step 5.
Switching from pulse to touch tone
dialing during a dialing sequence
If your phone line uses pulse (rotary) dialing, you can switch
from pulse to touch-tone dialing when sending a fax.
Depending on your telephone system, you may need to use
touch-tone dialing to enter the access number for your long-
distance service.