ZyXEL Communications NBG4115 - Manual (Page 60)

Chapter 5 AP Mode
User’s Guide
60
Note: If you change the IP address of the NBG4115 in the screen below, you will need
to log into the NBG4115 again using the new IP address.
Figure 28 Network > LAN > IP
The table below describes the labels in the screen.
Table 22 Network > LAN > IP
5.5 WLAN and Maintenance Settings
The configuration of wireless and maintenance settings in AP Mode is the same as
for Router Mode.
• See Chapter 5 on page 69 for information on the configuring your wireless
network.
• See Maintenance and Troubleshooting (179) for information on the configuring
your Maintenance settings.
LABEL DESCRIPTION
Get from
DHCP Server Select this to let the DHCP server in the gateway assign the NBG4115 IP
address.
User Defined
LAN IP Select this to give the NBG4115 a static IP address.
IP Address Type the IP address in dotted decimal notatiion. The default setting is
192.168.1.2. If you change the IP address you will have to log in again
with the new IP address.
IP Subnet
Mask The subnet mask specifies the network number portion of an IP address.
Your NBG4115 will automatically calculate the subnet mask based on the
IP address that you assign. Unless you are implementing subnetting, use
the subnet mask computed by the NBG4115.
Apply Click Apply to save your changes to the NBG4115.
Reset Click Reset to reload the previous configuration for this screen.