ZyXEL Communications NBG4115 - Manual (Page 166)

Chapter 17 Remote Management
User’s Guide
166
Remote Management and NAT
When NAT is enabled:
• Use the NBG4115’s WAN IP address when configuring from the WAN.
• Use the NBG4115’s LAN IP address when configuring from the LAN.
System Timeout
There is a default system management idle timeout of five minutes (three
hundred seconds). The NBG4115 automatically logs you out if the management
session remains idle for longer than this timeout period. The management session
does not time out when a statistics screen is polling. You can change the timeout
period in the System screen
17.2 WWW
To change your NBG4115’s World Wide Web settings, click Management >
Remote MGMT to display the WWW screen.
Figure 84 Management > Remote MGMT > WWW
The following table describes the labels in this screen.
Table 60 Management > Remote MGMT > WWW
LABEL DESCRIPTION
Server Port You may change the server port number for a service if needed,
however you must use the same port number in order to use that
service for remote management.
Server Access Select the interface(s) through which a computer may access the
NBG4115 using this service.