ZyXEL Communications NBG4115 - Manual (Page 113)

Chapter 8 WAN
User’s Guide
113
8.4 Advanced
Use this screen to enable Multicast, allow Windows Networking and enable
Auto-bridge.
Note: The three categories shown in this screen are independent of each other.
To change your NBG4115’s advanced WAN settings, click Network > WAN >
Advanced. The screen appears as shown.
Figure 59 Network > WAN > Advanced
The following table describes the labels in this screen.
Apply Click Apply to save your changes back to the NBG4115.
Reset Click Reset to begin configuring this screen afresh.
Table 39 Network > WAN > Internet Connection: Mobile 3G
LABEL DESCRIPTION
Table 40 WAN > Advanced
LABEL DESCRIPTION
Multicast Setup
Multicast
Check this to enable multicasting. This applies to traffic routed from
the WAN to the LAN.
Leaving this blank may cause incoming traffic to be dropped or sent
to all connected network devices.
Windows Networking (NetBIOS over TCP/IP)