ZyXEL Communications NBG4115 - Manual (Page 29)

Chapter 3 The Web Configurator
User’s Guide
29
• Select a language to go to the basic Web Configurator in that language. To
change to the advanced configurator see Chapter 23 on page 199
.
Figure 4 Selecting the setup mode
3.3 Resetting the NBG4115
If you forget your password or IP address, or you cannot access the Web
Configurator, you will need to use the RESET button at the back of the NBG4115
to reload the factory-default configuration file. This means that you will lose all
configurations that you had previously saved, the password will be reset to “1234”
and the IP address will be reset to “192.168.1.1”.
3.3.1 Procedure to Use the Reset Button
1
Make sure the power LED is on.
2
Press the RESET button for longer than 1 second to restart/reboot the NBG4115.
3
Press the RESET button for longer than five seconds to set the NBG4115 back to
its factory-default configurations.
3.4 Navigating the Web Configurator
The following summarizes how to navigate the Web Configurator from the Status
screen in Router Mode and AP Mode.