Xerox 700 - Manual (Page 48)

S ETTING UP THE I NTEGRATED F IERY C OLOR S ERVER FROM THE DIGITAL PRESS
CONTROL PANEL
48
The following table describes the access for the different security levels:
N OTE : Some of the utilities require that you set the security level to Minimum in an
SNMP v1 environment.
SNMP Read Community Name
public
Specify the SNMP Read Community Name. When it is changed, the new community name
must be entered to read any information in WebTools Configure. A maximum of 32 ASCII
characters, including spaces, can be used for the community name.
N OTE : A space at the beginning or end of the name is automatically deleted from the name
entered. When an invalid character is entered or no name is specified, the default “public” is
used for the Read Community name. A name consisting only of spaces is invalid.
SNMP Write Community Name
value
Specify the SNMP Write Community Name.
Unsecure User username
If you selected Minimum or Medium for Security Level, specify a user name for which
authentication and encryption are not used.
Secure User username
Specify a user name for which authentication (and if necessary, encryption) is used.
Authentication Type
MD5, SHA
Specify the type of authentication.
Authentication Password
Enter the password for reading MIB values based on the secure user name.
User Access Minimum Medium Maximum
SNMP v1 Read Yes Yes No
Write Yes No No
SNMP v3
Unsecure Read Yes Yes No
Write No No No
SNMP v3
Secure
Read Yes Yes Yes
Write Yes Yes Yes