Xerox 700 - Manual (Page 36)

S ETTING UP THE I NTEGRATED F IERY C OLOR S ERVER FROM THE DIGITAL PRESS
CONTROL PANEL
36
TCP/IP Setup
To configure the Integrated Fiery Color Server, choose each protocol and enter the settings
for that protocol. You can enable AppleTalk and TCP/IP communication simultaneously.
Ethernet Setup
When you set an IP address, subnet mask, or gateway address for the Integrated Fiery Color
Server during Setup, you can allow the Integrated Fiery Color Server to get these addresses
automatically from a DHCP or BOOTP server. First, turn on or restart the Integrated Fiery
Color Server and allow it to reach Idle. Make sure the DHCP or BOOTP server is running,
and then perform Network Setup.
IPv4 Address Type
Automatic, Manual
Choose whether to allow the Integrated Fiery Color Server to obtain its Ethernet IP address
automatically by searching the network. Depending on your network and the protocol you
select in the following option (DHCP or BOOTP), the IP address can change.
Network Setup
TCP/IP
Ethernet