Xerox 700 - Manual (Page 34)

S ETTING UP THE I NTEGRATED F IERY C OLOR S ERVER FROM THE DIGITAL PRESS
CONTROL PANEL
34
Network Setup options
When you perform Network Setup, you configure the Integrated Fiery Color Server to receive
jobs over the network systems that are used at your site, including setting network addresses
and names to be used by computers, servers, and the Integrated Fiery Color Server when they
communicate with each other. To access the Setup menu, follow the instructions on
page 23 .
Before performing Network Setup, confirm that the Integrated Fiery Color Server is
connected to an active network because the Integrated Fiery Color Server queries the network
for zones, servers, and server-based queues. If you perform Network Setup without a
connected and functioning network, default settings are used that may not meet your needs.
Configure options only for the network systems that are currently used at your site. If your
network requirements change, you can change Network Setup at any time. If the Integrated
Fiery Color Server is configured to enable more than one protocol, it automatically switches
to the correct protocol when it receives a print job.
Because Network Setup menus are nested, the names of higher-level menus are shown in this
chapter to the left of each menu heading. Default settings for options, where applicable, are
underlined.
Port Setup
Enter the settings for the Ethernet and USB ports, and for whether to restrict access from
MAC addresses.
Ethernet Speed
Auto, 10 Mbps Half-Duplex, 100 Mbps Half-Duplex, 10 Mbps Full-Duplex, 100 Mbps Full-
Duplex
Choose the appropriate speed of the network. Choose Auto in any of these cases:
• The network speed is unknown.
• The network environment is mixed.
• The network uses 1Gbps.
Network Setup
Port