ZyXEL Communications P-2302HWL-P1 Series - Manual (Page 281)

P-2302HW/HWL-P1 Series User’s Guide
Chapter 23 Troubleshooting 281
23.6.2 Incoming Calls
The following example shows the default behavior of your ZyXEL Device for incoming calls
when two SIP accounts are configured and you are using two phones. When a call comes in
from your SIP account 1, the phones connected to both phone port 1 and phone port 2 ring.
Similarly, when a call comes in from your SIP account 2, the phones connected to both phone
port 1 and phone port 2 ring. In either case you are not sure which SIP account the call is
coming from.
Figure 163 Incoming Calls: Default
In the next example, phone port 1 is configured to use SIP account 1 and phone port 2 is
configured to use SIP account 2 for incoming calls. In this case, every time you receive a call
from your SIP account 1, the phone connected to phone port 1 rings. Similarly, every time you
receive a call from your SIP account 2, the phone connected to phone port 2 rings. To apply
these configuration changes you need to configure the Analog Phone screen. See
Section 10.2
on page 159 .
Figure 164 Incoming Calls: Individual Configuration