ZyXEL Communications P-2302HWL-P1 Series - Manual (Page 220)

P-2302HW/HWL-P1 Series User’s Guide
220 Chapter 18 Remote MGMT
• Use the ZyXEL Device’s WAN IP address when configuring from the WAN.
• Use the ZyXEL Device’s LAN IP address when configuring from the LAN.
18.1.3 System Timeout
There is a default system management idle timeout of five minutes (three hundred seconds).
The ZyXEL Device automatically logs you out if the management session remains idle for
longer than this timeout period. The management session does not time out when a statistics
screen is polling. You can change the timeout period in the SYSTEM General screen.
18.2 Remote Management Screens
18.2.1 WWW Screen
Use this screen to control HTTP access to your ZyXEL Device. To access this screen, click
Management > Remote MGMT > WWW.
Figure 118 Management > Remote MGMT > WWW
Each field is described in the following table.
Table 95 Management > Remote MGMT > WWW
LABEL DESCRIPTION
Server Port Enter the port number this service can use to access the ZyXEL Device. The
computer must use the same port number.
Server Access Select the interface(s) through which a computer may access the ZyXEL Device
using this service.
Secured Client IP
Address Select All to allow any computer to access the ZyXEL Device using this service.
Select Selected to only allow the computer with the IP address that you specify to
access the ZyXEL Device using this service.
Apply Click this to save your changes and to apply them to the ZyXEL Device.
Cancel Click this to set every field in this screen to its last-saved value.