ZyXEL Communications P-2302HWL-P1 Series - Manual (Page 177)

P-2302HW/HWL-P1 Series User’s Guide
Chapter 13 VoIP Trunking 177
Each field is described in the following table.
13.6 Trunking Peer Call Screen
Use this screen to set up outgoing authentication accounts for forwarding calls through peer
devices and incoming authentication accounts for forwarding calls from peer devices. To
access this screen, click
VoIP > Trunking > Peer Call .
Table 74 VoIP > Trunking > General
LABEL DESCRIPTION
Enable Trunking Select this to turn on VoIP trunking on your ZyXEL Device.
Auto Attendant
Timeout(sec) This is the setting which determines how long the ZyXEL Device waits for a caller
to enter a phone number when it receives the call. Enter the number of seconds
before the Auto Attendant times out. The default value is 10 seconds and entering
0 does not change the default. Enter a value from 1 to 255 seconds.
When the auto attendant times out, the phone directly connected to the ZyXEL
Device rings.
Dialing
Interval(sec) Enter the number of seconds the ZyXEL Device should wait after you stop dialing
numbers before it makes the phone call. The value depends on how quickly you
dial phone numbers. The default value is 3 seconds and entering 0 does not
change the default. Enter a value from 1 to 255 seconds.
Enable Auto
Attendant
Authentication Select this to enable authentication for calls coming into your ZyXEL Device. This
is similar to enabling a PIN (Personal Identification Number) that callers must enter
to forward calls via your ZyXEL Device.
Password This is the PIN callers have to enter via their phone pad when dialing into your
ZyXEL Device to forward calls through it. Enter a number between 1 and 32 digits
long.
Apply Click this to save your changes and to apply them to the ZyXEL Device.
Cancel Click this to reset the fields.