Wayne-Dalton 9100 - Manual (Page 30)

Tools Needed:
30
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Drum Wrap Installation
Drum wraps are identified as right and
left hand.
To install, place the drum wrap over the
cable drum and under the idrive
®
disconnect cable (right hand side). Align
the outside flange over the outside edge
of the cable drum and push the drum
wrap down onto the cable drum. Repeat
for left hand side.
NOTE: Drum wraps must be installed to
prevent cable from becoming tangled.
IMPORTANT: RIGHT AND LEFT HAND
ARE ALWAYS DETERMINED FROM
INSIDE THE BUILDING LOOKING OUT.
DRUM
WRAP
CABLE
DRUM
DRUM
WRAP
CABLE
DRUM
None
OUTSIDE
FLANGE
Rear Support
KEEP HORIZONTAL TRACK
PARALLEL AND WITHIN 3/4”
MAXIMUM OF DOOR EDGE,
OTHERWISE DOOR COULD FALL,
RESULTING IN SEVERE INJURY OR
DEATH.
Raise the door until the top section and
half of the next section are in a horizontal
position. Do not raise door any further
since rear of horizontal track is not yet
supported.
RAISING DOOR FURTHER CAN
RESULT IN DOOR FALLING AND
CAUSE SEVERE INJURY OR DEATH.
Clamp a pair of vice clamps on the vertical
tracks just above the second roller on one
side, just below the second roller on the
other side. This will prevent the door from
raising or lowering while installing the rear
support.
Using perforated angle, 5/16” x 1-5/8”
33
34
WARNING
WARNING
Ratchet Wrench
1/2” Socket
1/2” Wrench
(2) Vice Clamps
Tape Measure
Level
Hammer
DOOR IN THE
UP POSITION
VERTICAL
TRACK
3/4”
VICE
CLAMPS
DOOR EDGE
HORIZONTAL
TRACK