Wayne-Dalton 9100 - Manual (Page 19)

19
Tools Needed:
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
INCORRECT
INST
ALLA
TION
Attaching Adjustable Flagangle
to Horizontal Track
NOTE: If quick install fl agangles were
installed in Step 14, skip this step and
continue with Step 16. If not, complete this
step.
To install horizontal track, place the curved
end over the top roller. Align the bottom of
the horizontal track with the vertical track.
Hand tighten the horizontal track to the
fl agangle with (2) 1/4” - 20 x 9/16” large
head ribbed track bolts (or stud plate if
included) and (2) 1/4”-20 fl ange hex nuts.
DO NOT RAISE DOOR UNTIL HORIZONTAL
TRACKS ARE SE CURED AT REAR, AS
OUTLINED IN STEP 34, OR DOOR COULD
FALL FROM OVERHEAD POSI TION CAUSING
SEVERE OR FATAL INJURY.
Level the horizontal track assembly and
bolt the horizontal angle to the slot in the
fl agangle using (1) 3/8” - 16 x 3/4” truss
head bolt and (1) 3/8” - 16 hex nut. Repeat
for other side. Remove the nail that was
temporarily holding the top section in
place, installed in Step 13.
IMPORTANT: FAILURE TO REMOVE NAIL
BEFORE ATTEMPTING TO RAISE DOOR
COULD CAUSE PERMANENT DAMAGE TO
TOP SECTION.
NOTE: If an
idrive ® opener will be installed,
position horizontal tracks slightly above
level.
15
16
7/16” Socket
9/16” Socket
Ratchet Wrench
9/16” Wrench
Level
FLAT TIP
SCREWDRIVER
1/4”-20 FLANGE
HEX NUTS
FLAGANGLE
1/4” - 20 X 9/16”
LARGE HEAD
RIBBED TRACK
BOLTS
STUD PLATE
WARNING
Adjusting Top Brackets
With horizontal tracks installed, you can
now adjust the top brackets.
Vertically align the top section of the
door with the lower sections. Once
aligned, position the top bracket slide,
out against the horizontal track.
Maintaining the slide’s position, tighten
the (2) 1/4” - 20 fl ange hex nuts to
secure the top roller slide to the top
bracket base.
HORIZONTAL
TRACK
TOP
BRACKET
SLIDE
(2) 1/4” - 20
FLANGE HEX
NUTS
CORRECT
7/16” Wrench
TOP
SECTION
TOP
SECTION
TOP
SECTION
3/8” - 16 X 3/4”
TRUSS HEAD BOLT 3/8” - 16 HEX NUT
HORIZONTAL TRACK
HORIZONTAL ANGLE