beautypg.com

Warning – Wayne-Dalton 9100 User Manual

Page 28

background image

Tools Needed:

28

Tools Needed:

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com

FAILURE TO PLACE VICE
CLAMPS ONTO VERTICAL TRACK
CAN ALLOW DOOR TO RAISE
AND CAUSE SEVERE OR FATAL
INJURY.

Place vice clamps onto both vertical
tracks just above the third roller. This is
to prevent the garage door from raising
while winding counterbalance springs.

IMPORTANT: DO NOT USE IMPACT GUN
TO WIND SPRING(S).

Securing Door

for Spring Winding

TRACK

VICE CLAMPS

ATTACHED TO

INNER RAIL

OF TRACK

Vice Clamp

COUNTERBALANCE

CABLE

SET SCREW

CABLE

DRUM

Locking Pliers

Flat Tip

Screwdriver

CAM PEAK

STRAIGHT UP

Rotate the cable drum until the set
screw faces directly away from the
header. TorqueMaster

®

spring tube cam

peak should be pointing straight up.

Beginning with the right side, loosen
the set screw enough to adjust cable,
approximately 2 turns. Using locking
pliers, pull on the end of the cable to
remove all cable slack.

Check to ensure the cable is aligned
and seated in the first groove of the
cable drum. Snug the set screw, then
tighten an additional 1-1/2 turns. Cut
excess cable.

Cable Adjustments

WARNING

29

30

PLACE VICE

CLAMPS ABOVE

3RD ROLLER