Wayne-Dalton 9100 - Manual (Page 25)

Tools Needed:
25
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
INST
ALLA
TION
Positioning Support Bracket
25
USING A TAPE MEASURE, MAINTAIN AN EQUAL MEASUREMENT “X”
(TOP OF DOOR TO BOTTOM OF TORQUEMASTER® TUBE) AT BOTH
ENDS AND THE CENTER.
TOP SECTION
“X” “X”
NOTE: See idrive ® main installation and
owners manual for idrive ® parts.
NOTE: idrive ® must be installed on a
solid mounting surface.
Locate the mounting surface. The
mounting surface is a vertical board
running directly above the center of the
door. Remove (2) 1/4”-20 flange nuts
from bottom of opener.
NOTE: Do not discard flange nuts.
Place the support bracket underneath
opener, to the right side of motor,
centered on mounting surface. Using a
tape measure, level the bottom of the
TorqueMaster
® spring tube to the top of
the door section with the idrive ® resting
on the support bracket. Once
TorqueMaster
® spring tube is level, drill
1/8” pilot holes for the lag screws. Then
secure support bracket to the mounting
surface with (2) 1/4” x 1-1/2" lag
screws.
IMPORTANT: TORQUEMASTER ® SPRING
TUBE MUST BE LEVEL AFTER SUPPORT
BRACKET IS FASTEN TO MOUNTING
SURFACE.
NOTE: If wood mounting surface is
behind dry wall, use 1/4” x 2” lag
screws.
Lift and slide the opener over the
support bracket, aligning the mounting
studs with the bracket slots. Loosely
fasten to mounting studs with the (2)
1/4”-20 flange nuts.
NOTE: Do not tighten 1/4”-20 flange
nuts to opener studs at this time.
Remove the temporary orange label
holding the antenna wire. Straighten
antenna wire and angle it 45 degrees to
the right.
NOTE: Do not coil the antenna wire.
This will reduce the radio signal range.
Power Drill
1/8” Drill Bit
7/16” Socket
Driver
45 ANGLE ANTENNA
WIRE
MOUNTING
SURFACE
(HEADER)
TOP OF DOOR
1/4” X
1-1/2” LAG
SCREWS
SUPPORT
BRACKET
1/4” - 20
FLANGE NUTS
MOUNTING
STUDS
MOUNTING
STUDS
BRACKET
SLOTS
SUPPORT
BRACKET
TORQUEMASTER ®
SPRING TUBE
(2) 1/4” - 20
FLANGE NUTS
TORQUEMASTER ®
SPRING TUBE
“X”