Wayne-Dalton 9100 User Manual

Page 24

Tools Needed:

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com

Counter Installation

Install the right side counter gear, with
the missing tooth toward the outside
and away from the end bracket. Press
the counter gear onto the end bracket
until snaps engage.

Select the right hand counter cover and
align the hex of the counter cam with
the end of the winding shaft. Also, align
the “0” on the counter cover with the
raised rib on the end bracket. Press the
counter cover against the counter gear
until it locks into place.

Repeat for left hand side for double
spring applications.

NOTE: No 36 tooth worm gear, counter
gear or counter cover is required on left
hand side for single spring applications.
Only an end bracket is needed.

IMPORTANT: AT THIS TIME DO NOT
WIND COUNTERBALANCE SPRINGS!

WINDING

SHAFT INSIDE

END BRACKET

MISSING

TOOTH

RAISED RIB

COUNTER

COVER

HEX OF THE

COUNTER CAM

COUNTER

GEAR

None

“0”

CENTER

BRACKET

BUSHING

ASSEMBLY

(2) 5/16” X 1-5/8”

HEX HEAD LAG

SCREWS

NOTE: If you are installing the idrive

opener on your garage door, skip this step
and continue with Step 25.

NOTE: If you are not installing the
idrive

opener on your garage door, you

must install the center bracket bushing
assembly. Follow these instructions for
non-idrive

operated garage doors.

NOTE: If you are installing a DoorMaster

™

opener, see optional DoorMaster

™

Bracket

installations on page 32, Figure B.

To locate the center bracket, mark the
header halfway between the ﬂ agangles
and level the TorqueMaster

spring tube.

Drill 1/8” pilot holes into header for the
lag screws. Fasten the metal bracket to
the header using (2) 5/16” X 1-5/8” lag
screws.

NOTE: Upon completion of this step, con-
tinue with Step 29.

Securing Center Bracket

Assembly