Wayne-Dalton 9100 User Manual

Page 23

Tools Needed:

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com

INST

ALLA

TION

Drive Gear Installation

End Brackets

Lubricating Oil

36 Tooth Worm

Gear

Beginning with the right hand side,
lubricate entire circumference of the 36
tooth worm gear with the lubricating oil
provided. Slide the 36th worm gear
onto the winding shaft splines until it
touches the flagangle.

NOTE: On single spring applications,
no drive gear is required on the left
side.

NOTE: If additional lubricating oil is
needed, use “Dura Lube

Engine Oil

Treatment”.

WINDING

SHAFT

SPLINES

FLAGANGLE

36 TOOTH

WORM GEAR

WINDING

SHAFT

CABLE

DRUM

CABLE

DRUM

IMPORTANT: WARNING TAGS MUST BE
SECURELY ATTACHED TO BOTH END
BRACKETS.

Slide the right hand end bracket over
the drive gear and fasten to the
flagangle using a #10 self-tapping
screw. Drill 3/16” pilot holes into jamb
for the lag screws. Secure end bracket
and the flagangle to the jamb using (2)
5/16” x 1-5/8" lag screws.

Repeat for left hand side.

(2) 5/16” X 1-5/8”

LAG SCREWS

#10 PHILLIPS

HEAD

SCREW

WARNING

TAG

Power Drill

3/16” Drill Bit

7/16”

Socket Driver

Phillips Head

Screwdriver

END BRACKET

LUBRICATING

OIL

36 TOOTH

WORM GEAR