beautypg.com

Dn dtr control, F load factory settings – Toshiba 6100 User Manual

Page 214

background image

User's Manual

C-8

A

PPENDIX

C

&C0

The state of the carrier from the remote modem is ignored.
DCD circuit is always on.

&C1

DCD turns on when the remote modem’s carrier signal is
detected, and off when the carrier signal is not detected
(default).

Result Codes:

OK

n=0,1

ERROR

Otherwise

&Dn DTR control

This command interprets how the modem responds to the state of the
DTR signal and changes to the DTR signal.

&D0

Ignore. The modem ignores the true status of DTR and treats
it as always on. This should only be used if your communica-
tion software does not provide DTR to the modem

&D1

If the DTR signal is not detected while in on-line data mode,
the modem enters command mode, issues an

OK

result code,

and remains connected.

&D2

If the DTR signal is not detected while in on-line data mode,
the modem disconnects (default).

&D3

Reset on the on-to-off DTR transition.

Result Codes:

OK

n=0,1,2,3

ERROR

Otherwise

&F

Load factory settings

This command loads the configuration stored and programmed at the
factory. This operation replaces all of the command options and the S-
register settings in the active configuration with factory values.

&F

Recall factory setting as active configuration.