Hw setup – Toshiba 6100 User Manual

Page 151

7-9

HW S

ETUP

AND

ASSWORDS

HW Setup

NOTES: 1. PC card HDD boot is supported only by slot 0 on the

computer. Support is guaranteed only for TOSHIBA PC
card HDDs.

2. When you assign a PC card HDD top priority, “PC” is not

displayed. However, the PC card HDD takes the position of
HDD in the Boot Priority Options list above.

To change the boot drive, follow the steps below.

1. Hold down

F12

and boot the computer.

2. The following menu will be displayed with the following icons: Built-in HDD,

Select Bay HDD, CD-ROM, FDD, Network (LAN), PCA (ATA) card boot.

NOTE: A bar will appear only under the selected device.

Use the left/right cursor keys to highlight the boot device you want and press

Enter

NOTES: 1. If a supervisor password is set, the menu above does not

appear when you use the user password to start the
computer.

2. In this computer, CD-ROM refers to the DVD-ROM or CD-

RW/DVD-ROM drives.

3. The selection method above does not change the boot

priority settings in HW Setup.

4. If you press a key other than one of those above or if the

selected device is not installed, the system will boot according
to the current setting in HW Setup.