Toshiba 6100 - Manual (Page 211)

C-5
A
PPENDIX
C
Result Codes:
OK n=0,1
ERROR Otherwise
On Return on-line to data mode
O0 Instructs the modem to exit on-line command mode and return
to data mode (see AT escape sequence, +++).
O1 This command issues a retrain before returning to on-line data
mode.
O3 This command issues a rate renegotiation before returning to
on-line data mode.
Result Codes:
OK n=0,1,3
ERROR Otherwise
P Select pulse dialing
This command configures the modem for pulse (non touch-tone)
dialing. Dialed digits are pulsed until a T command or dial modifier is
received. Tone dial is the default setting.
Qn Result code control
Result codes are informational messages sent from the modem and
displayed on your monitor. Basic result codes are
OK , CONNECT ,
RING , NO CARRIER , and ERROR . The ATQ command allows the
user to turn result codes on or off.
Q0 Enables modem to send result codes to the computer (de-
fault).
Q1 Disables modem from sending result codes to the computer.
Result Codes:
OK n=0,1
ERROR Otherwise
Appendix C