Oki lan 3100e - Manual (Page 95)

English
Chapter 6 - Troubleshooting 89
• If the printer connection cutoff message is issued
very often in the Remote Printer Mode, change
the notification settings with PCONSOLE. See
“Message display in remote printer mode” on
page 17.
When setting in NetWare 4.x and 5
environment
• You must set Printer Types of Remote Printer to
“Remote Other/Unknown”. See “Setting up
remote printer” on page 18.
• Set the printer number of Remote Printer to any
number 0 through 15. See “Setting up remote
printer” on page 18.
• To use the Okipage 14i printer in Queue Server
Mode, do not use the password for the print
server. See “Setting up remote printer” on
page 18.
• Match the print server name and the advertising
name. See “Setting up the remote printer using
the NetWare administrator utility” on page 18.
• Set up the service printer and assign the print
server and the print queue, without fail. See
“Setting up the remote printer using PCONSOLE
(except NetWare 5)” on page 22.
• This Network card does not support the Banner
Sheet in the Queue Server Mode. See “Setting up
queue server mode” on page 25.
• If the printer connection cutoff message is issued
very often in the Remote Printer Mode, change
the
notification settings with PCONSOLE
(except NetWare 5). See “Message display in
remote printer mode” on page 27.
When setting DHCP server environment
• We strongly recommend that IP address be used
fixed in DHCP server environment. See “IP
address setting in DHCP server environment” on
page 29.
• Do not set both DHCP and RARP to ENABLE at
the same time. See “IP address setting in DHCP
server environment” on page 29.
When printing in Macintosh environment
• Set Level2 menu PERSONALITY to “AUTO” or
“AdobePS”.
3100euGB.book Page 89 Friday, March 16, 2001 1:18 PM