Oki lan 3100e - Manual (Page 66)

60 OkiLAN 3100e Network Card
BYTE4 using the same procedure above as for
SM BYTE1.
Setting gateway address
1. Following the procedure of “Setting subnet
mask” above, press MENU1 button until GW
BYTE1 is displayed.
2. Change the address by pressing left arrow button
or right arrow button. (If you hold the button for a
several seconds, it will expedite the address
updating.) When the value to be set is displayed,
press the ENTER key to finalize it.
3. Press MENU1 button to move to GW BYTE2
setting. You can set up to and including GW
BYTE4 using the same procedure above as for
GW BYTE1.
4. After setting GW BYTE4, press ON-LINE
button. It will enable data to be received in TCP/
IP. To set NetWare ENABLE/DISABLE right
after this, press MENU1 button after GW BYTE4
is set.
Confirming the setting
1. Print the menu after completing the setting of
each address, to verify that the setting has been
made correctly.
2. Press ON-LINE button to set the printer to OFF-
LINE and hold the Print Menu button for 2
seconds or longer. When MENU HP PCL6* is
displayed, press ENTER button.
3. If the set values printed in the menu print are not
correct, set the values again.
Setting NetWare
NetWare enable/disable
To use this network card in the NetWare environment,
NetWare must be set to ENABLE on the printer’s
operator panel. To set the print server and the remote
printer, use the utility and the server.
1. Confirm that the printer is in the idle state from
the LCD panel and the indicator.
2. Press ON-LINE button to set the printer to OFF-
LINE, and hold MENU1 button for 2 seconds or
longer to display PRINT MODE.
3100euGB.book Page 60 Friday, March 16, 2001 1:18 PM