Oki lan 3100e - Manual (Page 86)

80 OkiLAN 320e Network Card
Cannot refer to printer settings or change them with
Telnet.
Has network excessive traffic or is there an abnormality?
NO
YES
Find the source of the problem and bring the
network back to a normal state.
Refer to Common Troubleshooting above
END
Can log in with Telnet. User name and password unnecessary. Fo
both, press Enter key.
Does login prompt user to input USER name displayed?
NO
YES
YES
NO
Is operation panel menu frame type set to Auto
Ether 2?
NO
YES
Set to Auto or Ether 2
Are IP address and subnet mask set correctly for
printer and host?
NO
YES
Set to Auto or Ether 2
When router exists between host and printer, is
router setting correct?
NO
YES
Set router correctly or access
printer from a host which
does not go through router.
When router exists between host and printer, is
default gateway setting correct?
NO
YES
Set default gateway correctly
for both printer and host.
Less than two Telnets are connected
simultaneously.
NO
YES
Close a Telenet session
3100euGB.book Page 80 Friday, March 16, 2001 1:18 PM