Oki lan 3100e - Manual (Page 17)

English
Chapter 3 - Network Setup 11
Installing as LPR printer
1. Open the [Control Panel] and double-click on
[Network and Dial-up connections].
2. Double-click on [Local Area Connection] and
click on [Properties].
3. Select [Internet Protocol (TCP/IP)] on [Local
Area Connection Properties] screen and click on
[Properties].
4. Enter [IP address], [Subnet mask], [Default
gateway] and [DNS server address], then click on
[OK].
Note: For the IP address setup when DHCP Server
is used, please refer to “IP address setting in
DHCP server environment” on page 29.
5. Close [Local Area Connection] screen.
6. Double-click on [Printers], then double-click on
[Add Printer].
7. [Add Printer Wizard] is displayed. For printer
management, select [Local printer] and click on
[Next>].
8. On the port selection screen, select [Create a new
port:] and [Standard TCP/IP Port], then click on
[Next>].
9. On [Add Standard TCP/IP Printer Port Wizard]
screen, select [Okidata Network Printer] in
[Standard] printer as [Device Type], then click on
[Next>].
10. On [Add Printer Wizard] screen, click on [Have
Disk...].
11. Insert the printer driver CD-ROM into the CD
drive and click on [OK].
12. Follow the on-screen instructions and install the
printer driver.
Note: By default, Windows will install the English
printer driver. To install a localised printer
d r i v e r i n y o u r l a n g u a g e , b r o w s e t o
D:\DRIVERS\WIN2000\Language on the
CD-ROM and run setup.exe from that
directory (where D:\ is the drive letter of
your CD-ROM drive; Language is your
language).
13. When the printer driver is installed, right-click on
the installed printer and select [Properties].
14. Click on [Print Test Page] button and the setup is
complete when the test pages are printed.
3100euGB.book Page 11 Friday, March 16, 2001 1:18 PM