Oki lan 3100e - Manual (Page 81)

English
Chapter 6 - Troubleshooting 75
Chapter 6 - Troubleshooting
Checking status codes
When an error occurs in data reception/transmission
using this network card, the printer’s LCD panel
displays HOST/IF ERROR. In this case, check the
status code using the following procedure, write down
the status code and consult your nearby service centre:
1. Clear the error by holding Recover button for 2
seconds or longer.
2. Hold the MENU1 button in OFF-LINE state for 2
seconds or longer to move to Menu2 setting.
When you have moved to that level, PRINT
MODE is displayed.
3. Press the MENU1 button repeatedly. When
NETWORK is displayed, press the ENTER
button to move to the Network setting mode.
4. Press the MENU1 button repeatedly. When NET
MNT is displayed, press the ENTER button
again. STATUS is displayed. At this point,
numbers indicating the error type are displayed
on the bottom column of the LCD.
5. Press left or right arrow button, then detailed
status codes from STATUS1 to STATUS18 are
displayed in numbers. Write down the status code
and consult your nearby service centre.
6. Press ON-LINE button to exit the menu setting
mode. The printer returns to the idle state.
3100euGB.book Page 75 Friday, March 16, 2001 1:18 PM