Oki lan 3100e - Manual (Page 9)

English
Chapter 2 - Installation 3
Chapter 2 - Installation
Printer installation
CAUTION:
The network card can be affected by static electricity. Do
not remove it from the antistatic bag until you are ready to
install it.
1. Turn the printer off and disconnect the power
supply cable from the printer.
2. Disconnect any interface cables from the printer.
3. Remove the blind plate from the rear panel of the
printer after separating it from the plastic
securing tabs.
4. Hold the network card (1) by the metal mount (2)
and insert it into the guides (3) on the printer.
5. Make sure that the expansion slots are upward
and the connector is toward the printer.
6. Push the network card (1) firmly but carefully
into the printer until the metal mount (2) comes
3100euGB.book Page 3 Friday, March 16, 2001 1:18 PM