Ricoh LD335c - Manual (Page 2)

Paper type: OK Prince Eco G100(55kg), Paper Thickness=80 µm // Pages in book=192 // Print scale=81%
Gap (when printed at 81% scale) = Pages in book × Paper thickness / 2 = 7.680000 mm
In accordance with IEC 60417, this machine uses the following symbols for the main power switch:
a a a a means POWER ON.
b b b b means POWER OFF.
c c c c means STAND BY.
Introduction
This manual contains detailed instructions and notes on the operation and use of this machine. For your
safety and benefit, read this manual carefully before using the machine. Keep this manual in a handy
place for quick reference.
Important
Contents of this manual are subject to change without prior notice. In no event will the company be li-
able for direct, indirect, special, incidental, or consequential damages as a result of handling or oper-
ating the machine.
Notes:
Some illustrations in this manual might be slightly different from the machine.
Certain options might not be available in some countries. For details, please contact your local dealer.
Laser Safety:
CDRH Regulations
This equipment complies with requirements of 21 CFR Subchapter J for class 1 laser products. This
equipment contains five AlGalnP laser diodes, 7–milliwatt, 645–660 nanometer wavelength for each
emitter. This equipment does not emit hazardous light, since the beam is totally enclosed during all cus-
tomer modes of operation and maintenance.
Caution:
Use of controls or adjustments or performance of procedures other than those specified in this manual
might result in hazardous radiation exposure.
Notes:
The model names of the machines do not appear in the following pages. Check the type of your ma-
chine before reading this manual. (For details, see P.17 “Machine Types”.)
• Type 1: C2824/DSc428/LD328c/Aficio 3228C
• Type 2: C3528/DSc435/LD335c/Aficio 3235C
• Type 3: C4535/DSc445/LD345c/Aficio 3245C
Certain types might not be available in some countries. For details, please contact your local dealer.
Two kinds of size notation are employed in this manual. With this machine refer to the inch version.
For good copy quality, the supplier recommends that you use genuine toner from the supplier.
The supplier shall not be responsible for any damage or expense that might result from the use of parts
other than genuine parts from the supplier with your office products.
Power Source
120V, 60Hz, 12A or more
Please be sure to connect the power cord to a power source as shown above. For details about power
source, see P.149 “Power Connection”.
Copyright © 2004