Ricoh LD335c - Manual (Page 140)

Troubleshooting
128
5
Changing the Paper Size
Preparation
Be sure to select the paper size
with User Tools and the paper size
selector. If you do not, misfeeds
might occur. See p.58 “Tray Paper
Size:Tray 2–4”.
Note
❒ Tray 1 and LCT (optional) use only
A4
Kpaper. To load 8 1 /
2
"
× 11"K,
contact your service representa-
tive.
❒ Procedures for changing the paper
size differ depending on the tray
(tray 1 or other optional paper tray
units). Make sure you are follow-
ing the appropriate procedure be-
fore you begin.
Reference
For details about paper sizes and
types, see p.173 “Copy Paper”.
Changing the Paper Size of the
Paper Tray
AAAA
Make sure the paper tray is not in
use. Then, pull the paper tray out
slowly.
BBBB
If paper is loaded in the tray, re-
move it.
CCCC
Set the paper guide lock to the
“unlocked" position.
DDDD
While pressing the release lever,
adjust the side guides to the paper
size.
EEEE
Adjust the end guide to the paper
size.
ZJKY270J
ZJKY280J
ZDJY802J
ZHXH760J
JupiterC2_GSG_EN_Pre_FM.book Page 128 Tuesday, December 28, 2004 1:39 PM