Ricoh LD335c - Manual (Page 125)

BLoading Paper
113
5
B B B BLoading Paper
Important
❒ Tray 1 and LCT use A4 Kpaper ex-
clusively. Load only A4 paper at
all times.
❒ If you want to load Letter- sized
paper (8 1 /
2
"
× 11"K) paper in Tray
1 or LCT, contact your sales or ser-
vice representative.
Reference
For paper types and sizes, see
p.173 “Copy Paper”.
To load paper in the bypass tray,
see “Copying from the Bypass
Tray”, Copy Reference.
Note
❒ Fan the paper before loading.
❒ Straighten curled or warped paper
before loading.
Loading Paper into Paper
Trays and Paper Tray Unit
Tray 1 uses only A4
Kpaper. If you
want to load 8 1 /
2
"
× 11"K, contact
your sales or service representative.
The position of the side and end
guides can be changed in tray 2, 1 tray
paper unit, and 2 tray paper unit. Pa-
per of various sizes can then be load-
ed in them.
This section describes loading paper
in tray 2.
AAAA
Pull out the paper tray until it
stops.
Note
❒ You can change the paper size,
see p.128 “Changing the Paper
Size”.
BBBB
Load paper into the tray with the
print side down.
Important
❒ Do not stack paper over the lim-
it mark.
CCCC
Push in the paper tray slowly un-
til it stops.
If a tray is pushed forcefully, the
position of its side guide may shift.
If you load a paper size that is not
selected automatically, you will
need to specify the paper size with
the control panel.
ZJKY270J
ZJKY290J ADL027S
JupiterC2_GSG_EN_Pre_FM.book Page 113 Tuesday, December 28, 2004 1:39 PM