Ricoh LD335c - Manual (Page 152)

Troubleshooting
140
5
HHHH
Compare the sample with the
printed pattern box at the bottom
of the Fuser Adjustment Sheet II.
Specify which square in the box
matches the sample.
If you specify “0”, setting is fin-
ished and the display that ap-
peared in step returns.
If you specify “-1” or “+1”, the fol-
lowing display appears.
Press [Start Printing]. An adjusted
Fuser Adjustment Sheet II is print-
ed and the display that appeared
in Step
H reappears. Keep adjust-
ing until the printed pattern looks
the same as the printed pattern,
and then specify “0”.
IIII
After making all the settings,
press the
{{{{User Tools/Counter}}}} key.
The initial display is shown.
JupiterC2_GSG_EN_Pre_FM.book Page 140 Tuesday, December 28, 2004 1:39 PM