Roland SH-32 - Manual (Page 34)

34
Modifying the Sound
5. Adding an Effect
You can add effects to the sound created so far. The SH-32 has two independent
effects processors; one of them provides spatial effects such as reverb and delay
(Reverb/Delay), while the other is used for inserting distortion, phaser, tremolo, and
other various effects (Insertion Effects).
fig.031
1
Press [INS-FX] or [REV/DELAY].
When you press [INS-FX], the button lights up, and the Insertion Effects is turned on.
When you press [REV/DELAY], the button lights up, and the Reverb/Delay
processor is turned on.
2
Select an effect type and set the rate.
To set the Insertion Effects, turn [INTENSITY] to adjust the intensity, and use the
FX/SYSTEM knob and [VALUE ▼/▲] to set the type and other details.
To set the Reverb/Delay, use the FX/SYSTEM knob and [VALUE ▼/▲] to set the
value.
The effect types and values are shown in the display. See “Chapter 3. Applying
Effects to the Sound (INS-FX, REV/DELAY)” (p. 64) for details.
Are you satisfied with the sound you created?
The sound settings created so far will be lost when you switch off the SH-32. Let’s
now save the sound into the internal memory.
See “Chapter 3. Applying
Effects to the Sound (INS-
FX, REV/DELAY)” (p. 64) for
details on effects.
Display
1
2
You can use the Insertion
Effects and Reverb/Delay at
the same time. You can also
line them up in series or in
parallel (p. 64).