Roland SH-32 - Manual (Page 108)

108
Effects List
DISTORTION 2
This is a distortion effect that provides heavy distortion.
fig.Distortion2
STEREO COMPRESSOR
Flattens out high levels and boosts low levels, smoothing out
fluctuations in volume.
fig.StComp
STEREO LIMITER
Compresses signals that exceed a specified volume level, preventing
distortion from occurring.
fig.StLimiter
PHASER
Adds a phase-shifted sound to the original sound, producing a
swirling modulation that creates spaciousness and depth.
fig.Phaser
ROTARY
This effect is based on the classic rotary speaker sound that can also
can be controlled with a knob.
fig.Rotary
HEXA-CHORUS
Uses a six-phase chorus (six layers of chorused sound) to give
richness and spaciousness to the sound.
fig.HexaChorus
Parameter Value Description
INTENSITY
(Drive)
0–127 Amount of distortion
Also changes the volume.
COLOR
(Amp Type)
[SML], [bLt],
[2St], [3St] Type of guitar amp
[SML]: small amp
[bLt]: single-unit type amp
[2St]: large double-stack amp
[3St]: large triple-stack amp
RATE (DEPTH)
(Tone)
0–127 Sound quality of the Distortion effect
LEVEL
(Level)
0–127 Output level
Parameter Value Description
INTENSITY
(Sustain)
0–127 Sets the duration of the compres-
sion.
COLOR
(Attack)
0–127 Sets the speed at which compres-
sion starts.
RATE (DEPTH)
(EQ Gain)
-15– +15 +: High boost
-: Low boost
LEVEL
(Post Gain)
0, +6, +12, +18 dB Adjusts the output gain.
Parameter Value Description
INTENSITY
(Threshold)
0–127 Adjusts the volume at which
compression begins.
COLOR
(Release)
0–127 Adjusts the time after the signal
volume falls below the Thresh-
old Level until compression is
no longer applied.
RATE (DEPTH)
(Ratio)
1.5:1, 2:1, 4:1, 100:1 Compression ratio
LEVEL
(Post Gain)
0, +6, +12, +18 dB Adjusts the output gain.
L in
R in
L out
R out
Amp
Simulator
Tone
Control
Distortion
L in
R in
L out
R out
Compressor
EQ
EQ
Compressor
L in
R in
L out
R out
Limiter
Limiter
Parameter Value Description
INTENSITY
(Rate)
0.05–10.0 Hz Frequency of modulation
COLOR
(Resonance)
0–110 Amount of feedback
RATE (DEPTH)
(Depth)
0–65 Depth of modulation
LEVEL
(Mix)
0–100 Level of the phase-shifted sound
Parameter Value Description
INTENSITY
(Rate)
0–127 Rotational speed of the rotors
COLOR
(Type)
[nor], [rEV] [nor]: As you turn INTENSITY to the
right (clockwise), the rotation of both
the upper range and lower range ro-
tors gets faster.
[rEV]: As you turn INTENSITY to the
right (clockwise), the rotation of the
upper range speeds up, while the low-
er range rotor slows.
RATE (DEPTH)
(Separation)
0–127 Adjusts the sound’s separation.
LEVEL
(Low Gain)
0–100% Relative volume level of the upper
range and lower range rotors.
Parameter Value Description
INTENSITY
(Balance)
0–100% Relative amount of chorus sound
COLOR
(Depth Deviation)
-20– +20 Adjusts the difference in modulation
depth between each chorus layer.
RATE (DEPTH)
(Rate)
0.05–10.0 Hz Frequency of modulation
LEVEL
(Depth)
0–127 Depth of modulation
Phaser
Resonance
Mix
L in
R in
L out
R out
L out
R out
L in
R in
Rotary
Balance W
Balance W
L in
R in
L out
R out
Hexa Chorus
Balance D
Balance D