Ricoh AFICIO MP01 - Manual (Page 55)

USING THE CONTROL PANEL
2-23
USING THE
CONTROL P
ANEL
Bi-Direction Selection
You use this selection to specify whether you want the printer to send status
readback messages to the host computer. The options are as follows:
❐ On - enables Bi-Direction mode
❐ Off - disables Bi-Direction mode
The default setting is On.
NIC Personality Submenu
From the Host Interface menu, press the [ ] key and press the [ 5 ] key or
the [
6
] key until “NIC Personality” displays on the Control Panel. You use this
submenu to specify the language interpreter for the network connection.
The NIC Personality submenu contains the following selections:
❐ PCL ❐ PS (PostScript     
)
❐ TIFF Raw Mode ❐ PS TBCP
❐ Auto Sense
The Auto Sense, PS (PostScript      ) and PS TBCP (Tagged Binar y
Communications Protocol) options display only when the PostScript

option is
installed. The default value is PCL. However, when the PostScript

option is
installed, the default value is Auto Sense.
Note: When the NIC Personality is set to PS (PostScript      ), the printer cannot
interpret PJL commands. If you use the PostScript  driver, Parallel or NIC
personality should be set to Auto Sense.