Ricoh AFICIO MP01 - Manual (Page 48)

USING THE CONTROL PANEL
2-16
The options are as follows:
❐ Off ❐ 1 hour
❐ 15 minutes ❐ 2 hours
❐ 30 minutes ❐ 3 hours
The default value is 15 minutes.
Low Toner Selection
You use this selection to specify whether you want the printer to continue to print
after a low toner condition is detected. The options are as follows:
❐ Continue - allows the printer to continue printing. Output becomes lighter
and may be unusable unless the toner cartridge is changed.
❐ Stop - causes the printer to stop printing.
The default value is Continue.
Resolution Selection
You use this selection to set the printer resolution for PCL output. The options
are as follows:
❐ 300 dpi
❐ 600 dpi
When the PostScript  option is installed, you can set the printer resolution for
PostScript

output. The options are as follows:
❐ 300 dpi
❐ 400 dpi
❐ 600 dpi
The default value for both PCL and PostScript  is 600 dpi.