Ricoh AFICIO MP01 - Manual (Page 45)

USING THE CONTROL PANEL
2-13
USING THE
CONTROL P
ANEL
System Submenu
From the Job Control menu, press the [ ] key and then press the [
5
] key
or the [ 6 ] key until “System” displays on the Control Panel. You use this submenu
to make changes to the operating status of the printer.
The System submenu contains the following selections:
❐ Jam Recovery
❐ Print PS Errors
❐ Edge Smoothing
❐ Toner Saving
❐ Time Out
❐ Energy Saver
❐ Low Toner
❐ Resolution
❐ Image Density
❐ PM (Preventive Maintenance)
Alarm
❐ Reset Fusing Ut (This menu
item displays only when the
Fusing Unit must be replaced.)
Jam Recovery Selection
You use this selection to enable the printer to recover automatically from paper
misfeed. The options are as follows:
❐ On - enables Jam Recovery. When a paper jam occurs, the printer reprints
all lost pages after you clear the paper jam.
❐ Off - disables Jam Recovery.
The default value is Off.
Note: When Jam Recovery is enabled, the printer can almost always recover all
lost pages. If a misfeed occurs in the Stapler the printer cannot reprint
lost pages.