Roland JUNO-Di - Manual (Page 99)

99
Effects List
This is an overdrive that provides heavy distortion.
This is a distortion effect that provides heavy distortion.
This is an effect that simulates the sound of a guitar amplifier.
Flattens out high levels and boosts low levels, smoothing out fluctuations
in volume.
Compresses signals that exceed a specified volume level, preventing
distortion from occurring.
Cuts the reverb’s delay according to the volume of the sound sent into
the effect. Use this when you want to create an artificial-sounding
decrease in the reverb’s decay.
This is a stereo delay.
A delay that provides a long delay time.
This is a monaural delay.
37: VS OVERDRIVE
Item Value Description
Amp Type
SMALL, BUILT-IN,
2-STACK, 3-STACK
Type of guitar amp
SMALL: small amp
BUILT-IN: single-unit type amp
2-STACK: large double stack amp
3-STACK: large triple stack amp
Drive 0–127
Degree of distortion
Also changes the volume.
Level 0–127 Output Level
38: VS DISTORTION
Item Value Description
Amp Type
SMALL, BUILT-IN,
2-STACK, 3-STACK
Type of guitar amp
SMALL: small amp
BUILT-IN: single-unit type amp
2-STACK: large double stack amp
3-STACK: large triple stack amp
Drive 0–127
Degree of distortion
Also changes the volume.
Level 0–127 Output Level
39: GUITAR AMP SIM
Item Value Description
Amp Type
JC-120,
CLEAN TWIN,
MATCH DRIVE,
BG LEAD, MS1959I,
MS1959II, MS1959I+II,
SLDN LEAD,
METAL 5150,
METAL LEAD,
OD-1,
OD-2 TURBO,
DISTORTION, FUZZ
Type of guitar amp
Amp Gain LOW, MIDDLE, HIGH Amount of pre-amp distortion
Level 0–127 Output level
40: COMPRESSOR
Item Value Description
Threshold 0–127
Adjusts the volume at which compression
begins
Level 0–127 Output level
41: LIMITER
Item Value Description
Threshold 0–127
Adjusts the volume at which compression
begins
Level 0–127 Output level
42: GATE
Item Value Description
Threshold 0–127 Volume level at which the gate begins to close
Level 0–127 Output level
43: DELAY
Item Value Description
Delay Time
0–1300 msec,
note Adjusts the time until the delay sound is
heard.
Feedback -98–+98%
Adjusts the amount of the delay sound that’s
fed back into the effect.
Negative (-) settings invert the phase.
Balance
D100:0W–
D0:100W Volume balance between the direct sound (D)
and the delay sound (W)
44: LONG DELAY
Item Value Description
Delay Time 0–2600 msec, note
Delay time from when the original
sound is heard to when the delay
sound is heard
Feedback -98–+98%
Proportion of the delay sound that
is to be returned to the input
(negative values invert the phase)
Balance D100:0W–D0:100W
Volume balance of the original
sound (D) and delay sound (W)
JUNO-Di_e.book 99 ページ ２００９年６月２２日 月曜日 午前９時２３分