Roland JUNO-Di - Manual (Page 96)

96
Effects List
The phaser effect will be varied gradually.
Extremely high settings of the phase difference produce a deep phaser
effect.
A phaser that continues raising/lowering the frequency at which the
sound is modulated.
This is an effect that applies amplitude modulation (AM) to the input
signal, producing bell-like sounds. You can also change the modulation
frequency in response to changes in the volume of the sound sent into
the effect.
This is a ring modulator that uses a 16-step sequence to vary the
frequency at which modulation is applied.
Cyclically modulates the volume to add tremolo effect to the sound.
Cyclically modulates the stereo location of the sound.
12: STEP PHASER
Item Value Description
Mode
4-STAGE, 8-STAGE,
12-STAGE
Number of stages in the phaser
Step Rate 0.10–20.00 Hz, note
Rate of the step-wise change in
the phaser effect
Mix 0–127 Level of the phase-shifted sound
Level 0–127 Output Level
13: MLT STAGE PHASER
Item Value Description
Mode
4-STAGE, 8-STAGE,
12-STAGE, 16-STAGE,
20-STAGE, 24-STAGE
Number of phaser stages
Rate 0.05–10.00 Hz, note Frequency of modulation
Mix 0–127 Level of the phase-shifted sound
Level 0–127 Output Level
14: INFINITE PHASER
Item Value Description
Mode 1, 2, 3, 4
Higher values will produce a
deeper phaser effect.
Speed -100–+100
Speed at which to raise or lower
the frequency at which the sound
is modulated
(+: upward / -: downward)
Level 0–127 Output volume
15: RING MODULATOR
Item Value Description
Frequency 0–127
Adjusts the frequency at which modulation is
applied.
Level 0–127 Output level
16:
STEP RING MOD
(STEP RING MODULATOR)
Item Value Description
Rate 0.05–10.00 Hz, note
Rate at which the 16-step sequence
will cycle
Level 0–127 Output volume
17: TREMOLO
Item Value Description
Mod Wave
TRI, SQR, SIN, SAW1,
SAW2
Modulation Wave
TRI: triangle wave
SQR: square wave
SIN: sine wave
SAW1/2: sawtooth wave
Rate 0.05–10.00 Hz, note Frequency of the change
Level 0–127 Output Level
18: AUTO PAN
Item Value Description
Mod Wave
TRI, SQR, SIN, SAW1,
SAW2
Modulation Wave
TRI: triangle wave
SQR: square wave
SIN: sine wave
SAW1/2: sawtooth wave
Rate 0.05–10.00 Hz, note Frequency of the change
Level 0–127 Output Level
SAW1 SAW2
SAW1 SAW2
L
R
L
R
JUNO-Di_e.book 96 ページ ２００９年６月２２日 月曜日 午前９時２３分