Removing batteries, When to replace the batteries (battery indicator), Connecting the external equipment – Roland JUNO-Di User Manual
Page 18: Connecting speakers or headphones, Amount remaining in the batteries (p. 18)
18
Getting Ready
2.
Insert the batteries into the battery compartment, taking
care to observe the correct polarity (+/- orientation).
fig.BattCase-2.eps
Carefully follow the installation instructions for batteries, and
make sure you observe the correct polarity.
3.
Securely close the battery compartment cover.
To remove the batteries, power off the JUNO-Di, open the battery
compartment cover, and remove the batteries.
When the batteries run down, the BATTERY indicator located at the left of
the display will light or blink.
• The BATTERY indicator will light when the batteries run low.
• If you continue using the JUNO-Di, the indicator will blink;
please recharge the batteries.
• If you continue use even though the indicator is blinking,
the display will indicate “Battery Low!” and further operation
will be impossible.
• The BATTERY indicator is only an approximation.
To reduce battery consumption, you can turn off the display’s
backlight when it is not required. Refer to “Turning the Display
You can also set the system setting “POWER SAVE MODE” to
save power. For details, refer to “Making Settings that are
Common to the Entire JUNO-Di (SYSTEM)” (p. 75).
Since JUNO-Di contains no amplifier or speakers, you’ll need to connect it
to audio equipment such as a keyboard amplifier, monitor speaker
system or home stereo, or use headphones to hear its sound.
In order to fully experience the JUNO-Di’s sound, we recommend using a
stereo amp/speaker system. If you’re using a mono system, however,
make your connections to the JUNO-Di’s OUTPUT L/MONO jack.
Audio cables are not included with the JUNO-Di. You’ll need to
provide them.
921
To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power
on all devices before making any connections.
fig.connect-output_e.eps
Removing Batteries
When to Replace the Batteries
(BATTERY Indicator)
Connecting the External Equipment
Connecting Speakers or Headphones
Stereo
headphones
Monitor speakers
(powered)
Power amp
Mixer etc.
JUNO-Di_e.book 18 ページ ２００９年６月２２日 月曜日 午前９時２３分