Roland JUNO-Di - Manual (Page 43)

43
Singing Along While You Play
Using a Microphone—MIC IN [VOLUME] Knob/[REVERB] Button
If you want to adjust the volume of the voice through the micro-
phone connected to the JUNO-Di, use the MIC IN [VOLUME] knob.
When you turn on the MIC IN [REVERB] button, a reverb effect is
added to the voice through the microphone. This effect is like the
echo when you sing karaoke.
You can adjust how much reverb is added to the micro-
phone. For more information about using the microphone, see “Making Settings that are
Common to the Entire JUNO-Di (SYSTEM)” on “Rev Level (Reverb Level)” (p. 76).
Select an effect with the “Vocoder” and add it to your voice through the microphone.
1.
Press the [VOCAL/PAD] button.
2.
Use the dial to select “036: VOCODER Ens.”
3.
Hold down the [SHIFT] button, and press the [PIANO] button.
The “MFX” screen is displayed.
“79:VOCODER” is selected as the effect type.
4.
Use the [ ] button to select the item that you want to set.
5.
Use the dial to change the setting.
Operation Changing vocoder settings
Item Value Description
Mic Sens 0 – 127
Adjusts the gain on the microphone
The higher you set this value, the higher the gain will be.
If you set the value too high, the tone through the microphone may be distorted.
Synth Level 0 – 127
Adjusts the input volume of the tone you select on the JUNO-Di
The higher you set this value, the louder the tone you play will be.
You will need to adjust the balance between this tone and the voice through the
microphone.
Mic Mix 0 – 127
Adjusts the balance between the voice without the vocoder effect and the voice
with the effect
The higher you set this value, the greater the tone without the vocoder effect will
be.
Level 0 – 127
Adjusts the volume of the voice with the vocoder effect
The higher you set this value, the greater the voice with the vocoder effect will be.
Important
Function
Memo
JUNO-Di_e.book 43 ページ ２００９年６月２２日 月曜日 午前９時２３分