Roland JUNO-Di - Manual (Page 59)

59
Detailed Tone Settings
The process of modifying a tone’s settings is called “patch editing (PATCH
EDIT).”
To edit the currently selected tone, proceed as follows.
1. Press the [MENU] button.
The “MENU” screen will appear.
2. Use the [ ] [ ] buttons to select “EDIT,” and press
the [ENTER] button.
3. Using the [ ] [ ] buttons, get “PATCH EDIT” to be
indicated in the upper line of the screen.
fig.disp-ptachedit.eps_70
You can access the edit screen of step 3 by holding down the
[SHIFT] button and pressing the [RHYTHM] button.
If you’re using split or dual, the part name is shown in the upper line
of the screen.
For split
U : Upper (UPPER) part
L : Lower (LOWER) part
For dual
1 : Part 1
2 : Part 2
4. Use the [ ] [ ] buttons to move the cursor to the
item that you want to edit.
5. Use the dial to set the desired value.
6. Press the [EXIT] button to leave the edit screen.
The changes you make are temporary; they will be discarded
when you turn off the power or select a different tone. If you
want to keep the changes you make, you must write them into
memory (p. 62).
When you use Patch Edit to modify the settings, an “*” will
appear next to the tone name in the main screen. The “*” will
disappear when you save that tone (p. 62).
Tone Settings
Editing a Tone’s Volume, Portamento,
Mono/Poly, or Bend Range (Patch Edit)
Item Value Description
Patch Level 0–127 Specifies the volume of the tone.
Portamento
Sw
OFF, ON
Specifies whether the portamento effect
will be applied (ON) or not (OFF).
* Portamento is an effect which smoothly
changes the pitch from the first-played
key to the next-played key. By applying
portamento when the Mono/Poly is
“MONO,” you can simulate slide
performance techniques on a violin or
similar instrument.
Portamento
Time
0–127
When portamento is used, this specifies
the time over which the pitch will change.
Higher settings will cause the pitch
change to the next note to take more
time.
Mono/Poly
MONO,
POLY
Specifies whether the patch will play
polyphonically (POLY) or monophonically
(MONO).
The “MONO” setting is effective when
playing a solo instrument patch such as
sax or flute.
MONO : Only the last-played note will
sound.
POLY : Two or more notes can be played
simultaneously.
Bend Range
Up
0–+48
Specifies the degree of pitch change in
semitones when the pitch bend lever is all
the way right.
For example, if this parameter is set to
“+12,” the pitch will rise one octave when
the pitch bend lever is moved to the right-
most position.
Bend Range
Down
0–-48
Specifies the degree of pitch change in
semitones when the pitch bend lever is all
the way left.
For example if this is set to “-48” and you
move the pitch bend lever all the way to
the left, the pitch will fall 4 octaves.
JUNO-Di_e.book 59 ページ ２００９年６月２２日 月曜日 午前９時２３分