Roland UA-25 - Manual (Page 41)

41
Driver installation and settings (Macintosh)
FreeMIDI settings
1
Set the UA-25 ADVANCE (mode select) switch to the ON
position.
2
Use the USB cable to connect the UA-25 to your
Macintosh.
3
From the CD-ROM, drag the Driver E (Mac OS 9) -
FreeMIDI Setting folder into the FreeMIDI Applications
folder on the hard disk of your Macintosh to copy it there.
4
Open the FreeMIDI Applications folder from the location
into which you installed FreeMIDI , and double-click the
FreeMIDI Setup icon to start it up.
5
The first time you start up, use the following procedure.
1. A dialog box saying “Welcome to FreeMIDI!” will
appear.
Click
[Continue] .
2. The FreeMIDI Preferences dialog box will appear.
Click [Cancel] .
3. The About Quick Setup dialog box will appear.
Click [Cancel] .
6
From the File menu, choose Open .
7
Select UA-25 from the FreeMIDI Setting folder you copied
in step 3 , and click [Open] .
8
Verify that MIDI transmission and reception occur
correctly.
From the MIDI menu, choose Check Connections .
If you are using the UA-25 in
conjunction with other MIDI
devices, make settings as
described in Readme_E.htm
located in the Driver E (Mac
OS 9)
folder of the CD-ROM.
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
connecting the USB cable is
required before the unit will
operate normally.
When “OMS is installed on
this computer...”
appears,
click [FreeMIDI].
If you are unable to select
Open
, make settings as
follows.
1. From the File menu, choose
FreeMIDI Preference .
2.
Uncheck “Use OMS when
available.”
3. Close FreeMIDI.
4.
Return to step 4 and
continue the procedure.
UA-25e.book 41 ページ ２００５年１０月３１日 月曜日 午後４時４８分