Roland UA-25 - Manual (Page 36)

36
Driver installation and settings (Macintosh)
Use either OMS or FreeMIDI as the MIDI driver.
The included UA-25 driver is an add-on module for using
the UA-25 with OMS or FreeMIDI.
* Either OMS or FreeMIDI must be installed in your
Macintosh, as appropriate for the sequencer software you are
using.
If you install OMS or FreeMIDI after installing the UA-25
driver, you must install the UA-25 driver once again.
Use the following procedure to install the UA-25 driver.
Disconnect the UA-25 from the Macintosh before you
perform the installation.
1
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure
to exit this as well.
2
Prepare the CD-ROM.Insert the CD-ROM into the CD-
ROM drive.
3
Double-click the UA-25 Driver-E Installer icon (found in
the Driver E (Mac OS 9) folder of the CD-ROM) to start
up the installer.
4
Verify the Install Location , and click [Install] .
Mac OS 9 users
Installing the UA-25driver
OMS can be found in the OMS
2.3.8 E
folder within the OMS
(Mac OS 9) folder of the CD-
ROM. If you would like to
know more about OMS, refer
to OMS_2.3_Mac.pdf which
can be found in the same
folder.
If a UA-25 is already connected to your Macintosh when you install the driver, a
message like the following will appear when the Macintosh is started up. Perform the
steps described below as appropriate for the message that is displayed.
If the screen indicates:
“Software needed for the USB device “UA-25” is not available. Would you like to
look for the software on the Internet?”
→ click [Cancel].
If the screen indicates:
“The software needed to use the USB device “UA-25” cannot be found. Please
refer to the device documentation to install the necessary software”.
→ click [OK].
UA-25e.book 36 ページ ２００５年１０月３１日 月曜日 午後４時４８分