RAD Data comm 10/100BaseT to STM-1/OC-3 Converter RIC-155 - Manual (Page 49)

RIC-155 Installation and Operation Manual Chapter 4 Configuration
Configuring the Internal Bridge 4-13
RIC-155
Bridge Configuration
Aging Time (sec) (314)
Bridging Mode (Filter)
Statistics Counted (OK only)
Multicast and Broadcast Rate Limit > (8 Mbps)
Bridge Ports >
Please select item <1 to 5>
ESC-prev.menu; !-main menu; &-exit
Figure 4-14. Bridge Configuration Menu
Configuring the Bridge Ports
The RIC-155 internal bridge includes four ports: Ethernet management, Ethernet
data, POS (STM-1/OC-3c link) and host. The bridge ports can be used for isolating
management traffic from data traffic, serving as an important security tool.
Appendix B details the RIC-155 traffic separation mechanism.
To access the Bridge Port menu:
• Follow the path: Configuration > Bridge Configuration > Bridge Ports.
The Bridge Ports menu is displayed.
RIC-155
Bridge Ports
1. DATA Port
>
2. MNG Port >
3. POS Port Egress > (Unmodified)
Please select item <1 to 3>
ESC-prev.menu; !-main menu; &-exit
Figure 4-15. Bridge Ports Menu
Configuring Ethernet Management and Data Bridge Ports
The Ethernet management and data bridge ports support VLAN tagging and VLAN
prioritization. In addition, these ports can be configured to strip VLAN tags at
egress or leave the frames unmodified.
To configure the Ethernet management and data bridge ports:
1. From the Bridge Ports menu, select DATA Port or MNG Port.
The DATA Port or MNG Port menu appears.
2. From the DATA Port or MNG Port menu, configure the following:
PVID (ID of the VLAN assigned to the current port): 1–4094.
PVID Priority (priority of the assigned VLAN): 0–7