RAD Data comm 10/100BaseT to STM-1/OC-3 Converter RIC-155 - Manual (Page 12)

Quick Start Guide RIC-155 Installation and Operation Manual
2 Configuring RIC-155
4. When the ALM LED (red) starts blinking, press several times.
RIC-155 automatically adjusts itself to the current terminal baud rate and
responds with a string of dots.
5. Type several dots.
When the hardware initialization is completed, the SIG and ALM LEDs
flash rapidly six times.
6. Press to display the user name and password entry form.
7. Enter your user name and password and proceed with the management
session.
The RIC-155 default user names are SU and USER, default password is 1234.
Configuring RIC-155
The management software provides a Quick Setup menu, which includes the most
basic parameters necessary for configuration.
To configure RIC-155:
• From the Quick Setup menu (Main > Configuration > Quick Setup),
configure the following parameters:
Master Clock
Host IP address
Host IP mask
Default Gateway
Host Tagging
Host VLAN ID
Host VLAN Priority
Forwarding Mode
Physical Port Management Access
SDH/SONET frame type.
Note